This a blued safety delete pin and stud with a BRASS saddle ring as shown. The brass ring is closed and polished but is not welded. This is an UP/DOWN configured ring.
This replaces the factory crossbolt safety on a Marlin 1894, 1895 or 336 lever action rifle at the owner's discretion. This piece fits all Marlin centerfire lever-action rifles. It does not fit the Marlin 39A .22 caliber rifles. This part comes with a 5/64" allan wrench for installation.
Additional installation hardware options available. Take a look at the Set Screw and Lock Pin
Installation instructions HERE
Determining whether or not disabling the factory cross-bolt safety is appropriate is the responsibility of the firearm's owner or user. By purchasing this product and installing it you are assuming all responsibility and consequences that may result from altering the factory cross-bolt safety that comes with the firearm. Disabling the factory cross-bolt safety can result in an increased possibility of accidental discharge that could result in injury or worse. Additional caution and special attention should be used when using a firearm with a disabled cross-bolt safety. Always treat a firearm as if it could discharge at any moment to avoid accidents.